Dell LCD TV W4201C - Manual (Page 42)

42 Troubleshooting Problems With Your TV
w
w
w
.d
el
l.
co
m
|
s
up
po
rt
.d
el
l.
co
m
FILE LOCATION: D:\manual\Dell\W4201OM\approval-B\ch5e.fm
DELL CONFIDENTIAL – PRELIMINARY 12/28/05 – FOR PROOF ONLY
PIP/POP/PBP not working 1
Ensure the settings in the TV Menu are properly set. Press Menu
to enter the TV Menu, and select PIP/POP/PBP.
2
Swap the video and audio source.
No video NOTE: If you see a self-test, it means there is a problem with your
video card or you are using the wrong input source.
1
Ensure the TV is turned on.
2
Verify that all the cables are properly connected to the TV,
including the power cable.
3
Check to see if there is a blue or amber light on the lower, right-
hand corner of the TV. A blue light indicates the TV is on. An
amber light, means the TV is in power save mode.
4
Ensure proper source is selected. See "Input Select" on page 28
for more information.
5
Reconnect the computer.
6
Connect another device that you know is working properly.
7
Reset the original factory defaults. Press Menu on the remote
control, select Setup, and then select Factory Reset.
Problem Possible Solution
DZ101_UM-ALL.book Page 42 Wednesday, December 28, 2005 6:43 PM