Dell Precision T5400 (Late 2007) - Manual (Page 252)

252 Adding and Replacing Parts
8 If no screws are attached to the drive, remove the shoulder screws from the
inside of the drive panel and attach the screws to the new drive.
9 Gently slide the drive into the FlexBay until you hear a click or feel the
drive securely installed.
10 Attach the power and data cables to the floppy drive.
11 Connect the other end of the data cable to the system board connector
labeled "DSKT." To locate the system board connector, see "System Board
Components" on page 28.
1 drive 2 screws
1
2