Dell 1815dn Multifunction Mono Laser Printer User Manual
Page 72

Static Addressing
To enter the TCP/IP address from your printer's operator panel, take the following steps:
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Network CFG and press Select (
).
3.
Press Scroll (
or
) to highlight Configuration and press Select (
).
4.
Press Scroll (
or
) to highlight TCP/IP and press Select (
).
The first available menu item, Manual, appears and press Select (
).
5.
The first available menu item, IP Address displays.
6.
Press Select (
) to access the IP Address menu.
7.
Enter the numbers from the keypad and use Scroll (
or
) to move between octets and press Select (
).
8.
Enter other parameters, such as the Subnet Mask, GateWay or Primary DNS, and press Select (
).
9.
After entering all parameters, press Cancel (
) to return to Standby mode.
An IP address consists of 4 bytes.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network.
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Network CFG and press Select (
).
3.
Press Scroll (
or
) to highlight Configuration and press Select (
).
4.
Press Scroll (
or
) to highlight TCP/IP and press Select (
).
5.
Press Scroll (
or
) to highlight DHCP and press Select (
).
To assign the address from the BOOTP server, press Select (
) when BOOTP displays.
Restoring the Network Configuration
You can return the network configuration to its default settings.
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Network CFG and press Select (
).
3.
Press Scroll (
or
) to highlight Clear Settings and press Select (
).
The first available menu item, Yes displays on the bottom line.
4.
Press Select (
) to restore the network configuration.
5.
Power the printer off and back on or reset the network interface card.