Dell 2130cn Color Laser Printer - Manual (Page 30)

To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network settings are reset to their default values.
TCP/IP
Purpose:
To configure TCP/IP settings. Any changes made become effective after the printer is turned off and then on.
Values:
Protocol
Purpose:
To enable or disable each protocol. Any changes made become effective after the printer is turned off and then on.
Values:
IP Filter
Purpose:
NOTE: This item is only displayed when an optional wireless printer adapter is installed.
IP Mode
Dual Stack*
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode
Uses IPv6 to set the IP address.
IPv4
Get IP Address
AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address Sets the IP address allocated to the printer by using the keys on the operator panel.
Subnet Mask Sets the subnet mask.
Gateway Address Sets the gateway address.
IPsec* 1 Disables IPsec.
* 1 Only displayed when an optional network protocol adapter is installed and IPsec is enabled.
LPD
Enable* Enables the LPD port.
Disable Disables the LPD port.
Port9100
Enable* Enables the Port9100 port.
Disable Disables the Port9100 port.
NetWare* 1 NetWare IP
Enable* Uses IP for NetWare.
Disable Does not use IP for NetWare.
WSD* 1
Enable* Enables the WSD port.
Disable Disables the WSD port.
SNMP SNMP UDP
Enable* Enables the UDP.
Disable Disables the UDP.
E-Mail Alert
Enable* Enables the Email Alerts feature.
Disable Disables the Email Alerts feature.
EWS
Enable* Enables an access to Dell Printer Configuration Web Tool embedded in the printer.
Disable Disables an access to Dell Printer Configuration Web Tool embedded in the printer.
HTTP-SSL/TLS* 2
Enable* Enable the HTTP-SSL/TLS.
Disable Disable the HTTP-SSL/TLS.
* 1 Only displayed when an optional network protocol adapter is installed.
* 2 Only displayed when an optional network protocol adapter is installed and which is authenticated by EWS.