Dell Latitude D630 - Manual (Page 136)

136 System Setup Program
Viewing the System Setup Screens
1 Turn on (or restart) your computer.
2 When the DELL™ logo appears, press immediately. If you wait too
long and the Microsoft ® Windows ® logo appears, continue to wait until
you see the Windows desktop. Then shut down your computer and try
again.
System Setup Screens
NOTE: For information about a specific item on a system setup screen, highlight the
item and see the Help area on the screen.
On each screen, the system setup options are listed at the left. To the right of
each option is the setting or value for that option. You can change settings that
appear as white type on the screen. Options or values that you cannot change
(because they are determined by the computer) appear less bright.
The upper-right corner of the screen displays help information for the currently
highlighted option; the lower-right corner displays information about the
computer. System-setup key functions are listed across the bottom of the screen.
Commonly Used Options
Certain options require that you reboot the computer for new settings to take
effect.
Changing the Boot Sequence
The boot sequence, or boot order, tells the computer where to look to find the
software needed to start the operating system. You can control the boot
sequence and enable/disable devices using the Boot Order page of the system
setup program.
NOTE: To change the boot sequence on a one-time-only basis, see "Performing a
One-Time Boot" on page 137.
The Boot Order page displays a general list of the bootable devices that may be
installed in your computer, including but not limited to the following:
• Diskette Drive
• Modular bay HDD