Dell PowerEdge 2650 - Manual (Page 41)

SEC
Abbreviation for single-edge contact.
serial port
An I/O port used most often to connect a modem to your system. You can usually identify a serial port on your system by its 9-pin connector.
service tag number
A bar code label on the system that identifies it when you call Dell for customer or technical support.
SIMM
Acronym for single in-line memory module. A small circuit board containing DRAM chips that connects to the system board.
SMART
Acronym for Self-Monitoring Analysis and Reporting Technology. A technology that allows hard drives to report errors and failures to the system BIOS, which
then displays an error message on the screen. To take advantage of this technology, you must have a SMART-compliant hard drive and the proper support in
the system BIOS.
SMP
Abbreviation for symmetric multiprocessing. SMP is a system that has two or more microprocessors connected via a high-bandwidth link and managed by an
operating system, where each microprocessor has equal access to I/O devices. This is in contrast to parallel processing, where a front-end microprocessor
handles all I/O to disks, terminals, local area networks, and so on.
SNMP
Abbreviation for Simple Network Management Protocol. SNMP is an industry-standard interface that allows a network manager to remotely monitor and
manage workstations.
SRAM
Abbreviation for static random-access memory. Because SRAM chips do not require continual refreshing, they are substantially faster than DRAM chips.
SVGA
Abbreviation for super video graphics array. VGA and SVGA are video standards for video adapters with greater resolution and color display capabilities than
previous standards.
To display a program at a specific resolution, you must install the appropriate video drivers and your monitor must support the resolution. Similarly, the number
of colors that a program can display depends on the capabilities of the monitor, the video driver, and the amount of video memory installed in the system.
switch
On a system board, switches control various circuits or functions in your system. These switches are known as DIP switches; they are normally packaged in
groups of two or more switches in a plastic case. Two common DIP switches are used on system boards: slide switches and rocker switches. The names of the
switches are based on how the settings (on and off) of the switches are changed.
system board
As the main circuit board, the system board usually contains most of your system's integral components, such as the following:
l Microprocessor
l RAM
l Controllers for standard peripheral devices, such as the keyboard
l Various ROM chips
Frequently used synonyms for system board are motherboard and logic board.
system configuration information
Data stored in memory that tells a system what hardware is installed and how the system should be configured for operation.
system diskette
System diskette is a synonym for bootable diskette.
system memory
System memory is a synonym for RAM.
System Setup program
A BIOS-based program that allows you to configure your system's hardware and customize the system's operation by setting such features as password
protection and energy management. Some options in the System Setup program require that you reboot the system (or the system may reboot automatically)
in order to make a hardware configuration change. Because the System Setup program is stored in NVRAM, any settings remain in effect until you change them
again.
system.ini file