Rebooting the system, Configuring special keys, Configuring the ports – Dell PowerEdge 2650 User Manual
Page 14: Configuring the terminal settings

Configuring Console Redirection on the Client System
Configuring the Ports
1.
Click the Start button, point to Programs—> Accessories—> Communications, and click HyperTerminal.
2.
Enter any name for the new connection and select any icon.
3.
Click OK.
4.
From the Connect to pull-down menu, select a COM port available on your client system and click OK.
If no COM port is available and you do not have a Dell system, you will need to contact technical support for your client system.
After you have selected an available COM port, the COM port properties window is displayed.
5.
Select Bits per second.
Console redirection supports 9600, 19.2 K, 57.6 K, or 115.2 K bps.
6.
Set Data bits to 8.
7.
Set Parity to None.
8.
Set Stop bits to 1.
9.
Set Flow control to Hardware.
10.
Click OK.
Configuring the Terminal Settings
After you configure the ports, configure the terminal settings by performing the following steps:
1.
In HyperTerminal, click File, click Properties, and select the Settings tab.
2.
Ensure that the Function, arrow, and ctrl keys act as field is set to Terminal Keys.
3.
Ensure that the Backspace key sends field is set to Ctrl+H.
4.
Change the Emulation setting from Auto detect to ANSI or VT100/220.
This setting should be the same as the setting you selected for the Console Redirection option on the server.
When you click Terminal Setup, you should see a setting for the number of rows and columns.
5.
Change the number of rows from 24 to 25 and leave the number of columns at 80. If you do not have these settings, this is an indication that you must
upgrade your terminal emulation software.
Rebooting the System
Console redirection is designed to yield control of the serial ports to the operating system. This configuration allows serial debugging and redirection of the
operating system to function correctly without interference from the system BIOS.
To use console redirection to shut down a system and troubleshoot it or to change SCSI BIOS configurations, perform the following steps:
1.
, for a recommendation on how to do this.
2.
When the system begins to reboot, use console redirection to watch and interact with the system during the POST. While the system is booting, you
can do the following:
l
Enter the System Setup program.
l
Enter the SCSI setup menus.
l
Run utilities on the utility partition.
l
Update firmware and BIOS (flash the system).
Configuring Special Keys
Console redirection uses ANSI or VT100/220 terminal emulation, which are limited to basic ASCII characters. There are no function keys, arrow keys, or control
keys in this character set. However, most BIOS software requires the use of function keys and control keys for ordinary functions. You can emulate a function
key or control key by using a special key sequence, called an escape sequence, to represent a specific key.
NOTE:
The examples in this document assume that you have upgraded to Hilgraeve's HyperTerminal Private Edition 6.1 or later. If you are using other
terminal emulation software, see the help file for that software.
NOTE:
To use console redirection to run utilities on the utility partition, the utility partition must have been created using Dell OpenManage™
Server Assistant version 6.3.1 or later.