Dell LATITUDE C510 - Manual (Page 65)

CD drive controller failure -
The CD drive does not respond to commands from the computer. See " Drive
Problems ."
Data error -
The floppy or hard drive cannot read the data. See " Drive Problems ."
Decreasing available memory -
One or more memory modules may be faulty or improperly seated. Reseat the
memory modules and, if necessary, replace them. See "
Adding Memory ."
Disk C: failed initialization -
The hard drive failed initialization. Run the Hard-Disk Drive tests as described in
"
Using Dell Diagnostics ."
Floppy drive 0 seek failure -
The system configuration information may not match the hardware configuration. Run
the Diskette tests as described in "
Using Dell Diagnostics ."
Diskette read failure -
The floppy disk may be defective. If the light turns on, try a different disk. See
" Drive Problems ."
Diskette subsystem reset failed -
The floppy drive controller may be faulty. Run the Diskette tests as described in
"
Using Dell Diagnostics ."
Diskette write-protected -
Because the floppy disk is write-protected, the operation cannot be completed. Slide
the write-protect notch.
Drive not ready -
The operation requires a floppy disk in the drive or a hard drive in the bay before it
can continue. Insert a floppy disk, or push the floppy disk all the way into the drive
until the eject button pops out. Or,
install a hard drive in the hard drive bay.
Error reading PCMCIA card -
The computer cannot identify the PC Card. Reinsert the card or try another PC Card.