Dell PowerVault MD3000 - Manual (Page 173)

Script Commands
173
NOTE:
When you use this command, you can specify one or more of the optional
parameters. You do not, however, need to use all of the parameters.
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Examples
-c "set host [job2900] hostGroup=none userLabel=
\"job2900\" hostType=0;"
-c "set host [\"pe2900\"] userLabel=\"pe2901\";"
Set Host Group
This command renames a host group.
Syntax
set hostGroup [ hostGroupName ] userLabel=
" newHostGroupName "
none The host is removed from
the host group as an
independent partition and is
placed under the root node. The host is removed from the
present host group and is
placed under the default
group.
defaultGroup The command fails. The host is removed from the
present host group and is
placed under the default
group.
Host Group Parameter Host Has Individual Virtual
Disk-to-LUN Mappings Host Does Not Have Individual
Virtual Disk-to-LUN Mappings