Dell PowerVault MD3000 - Manual (Page 201)

Script Commands
201
Parameters
Show RAID Controller Module NVSRAM
This command returns a list of the NVSRAM byte values for the specified
host type. If you do not enter the optional parameters, this command returns
a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)])
NVSRAM [hostType=( hostTypeIndexLabel | host=
" hostName ")]
Parameter Description
allControllers Returns information about both RAID controller modules in the
storage array.
controller Returns information about a specific RAID controller module in
the storage array. Valid RAID controller module identifiers are 0
or 1, where 0 is the RAID controller module on the left and 1 is
the RAID controller module on the right when viewed from the
rear of the enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
NOTE:
The detailed RAID controller module information is also
returned for the show storageArray command.
summary Returns a concise list of information about both RAID
controller modules in the storage array.
NOTE:
When you use the summary parameter, the command
returns the list of information without the physical disk channel and
host channel information.