Dell PowerVault MD3000 - Manual (Page 167)

Script Commands
167
Syntax
set controller [(0 | 1)]
availability=(online | offline | serviceMode) |
bootp |
ethernetPort [1] = ethernet-port-options
globalNVSRAMByte [ nvsramOffset ]=
( nvsramByteSetting | nvsramBitSetting ) |
hostNVSRAMByte [ hostType, nvsramOffset ]=
( nvsramByteSetting | nvsramBitSetting ) |
iscsiHostPort [(1 | 2)] = iscsi-host-port-options
rloginEnabled=(TRUE | FALSE) |
serviceAllowedIndicator=(on | off)
Parameters
Parameter Description
controller This parameter is the RAID controller module for which
you want to define properties. Valid identifiers for the
RAID controller module are 0 or 1, where 0 is the RAID
controller module on the left and 1 is the RAID controller
module on the right when viewed from the rear of the
RAID enclosure. You must put square brackets ([ ]) around
the identifier for the RAID controller module. If you do
not specify a RAID controller module, the firmware for the
RAID controller module returns a syntax error.
availability This parameter sets the mode for the RAID controller
module to online, offline, or service
(serviceMode).
bootp This parameter causes a RAID controller module to find a
BOOTP server. The BOOTP server then assigns an IP
address to the RAID controller module.
ethernetPort This parameter defines the attributes (options) for the
management Ethernet ports. Refer to Table 2-4 for a list of
the attributes that you can set.
Valid Ethernet port identifiers are 1 or 2. You must put
square brackets ([ ]) around the Ethernet port identifier.