Dell PowerVault MD3000 - Manual (Page 215)

Script Commands
215
Parameters
Start Enclosure Blink
This command identifies an enclosure by turning on the indicator LED. (Use
the stop enclosure blink command to turn off the indicator LED for the
enclosure.)
Syntax
start enclosure [ enclosureID ] blink
Parameters
Start iSCSI DHCP Refresh
This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP,
the procedure returns an error.
Syntax
start storageArray [ iscsi-host-port ] dhcpRefresh
Parameter
Parameter Description
diskGroup Number of the disk group to defragment. You
must put brackets ([ ]) around the disk group
number.
Parameter Description
enclosure Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Parameter Description
iscsi-host-port The identifier of the port on the storage array on which you want to
refresh the DHCP parameters. Enclose the iSCSI host port name in
square brackets
([ ]).