Dell PowerVault MD3000 - Manual (Page 168)

168
Script Commands
NOTE:
When you use this command, you can specify one or more of the
parameters. You do not, however, need to use all of the parameters.
NOTE:
Setting availability to serviceMode causes the alternate RAID
controller module to take ownership of all virtual disks. The specified RAID
controller module no longer has any virtual disks and refuses to take ownership of
any more virtual disks. Service mode is persistent across reset and power cycles
until the
availability parameter is set to online .
NOTE:
Use the show controller NVSRAM command to display parts or all
of the NVSRAM.
globalNVSRAMByte This parameter modifies a portion of the RAID controller
module NVSRAM. Specify the region to be modified using
the starting byte offset within the region, and the size and
value of the new data to be stored into NVSRAM.
hostNVSRAMByte This parameter updates the NVSRAM for the host specific
region. Specifies the host index for the specific host, the
starting offset within the region, the number of bytes, and
the values to be written.
iscsiHostPort This parameter defines the attributes (options) for the
host Ethernet ports. Refer to Table 2-5 for a list of the
attributes that you can set.
Valid Ethernet port identifiers are 1 or 2. You must put
square brackets ([ ]) around the Ethernet port identifier.
rloginEnabled This parameter defines whether the remote login feature is
turned on or turned off. To turn on the remote login
feature, set this parameter to TRUE. To turn off the
remote login feature, set this parameter to FALSE.
serviceAllowedIndicator This parameter defines whether the Service Action
Allowed indicator light is turned on or turned off. To turn
on the Service Action Allowed indicator light, set this
parameter to on. To turn off the Service Action Allowed
indicator light, set this parameter to off.
Parameter Description