Installing a memory module, Removing memory riser boards, 1 remove the microprocessor airflow shroud – Dell PRECISION 530 User Manual
Page 50: B lift the bracket away from the chassis, 3 remove memory riser board a
50
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
I n s t a l l i n g a M e m o r y M o d u l e
Removing Memory Riser Boards
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
1
Remove the microprocessor airflow shroud
.
2
Remove the memory riser board retention bracket (see the following
figure).
a
Lift the retention bracket up to disengage it from the chassis.
b
Lift the bracket away from the chassis.
NOTICE:
To avoid damage to the memory riser board, press the securing clips
with equal force applied at each end of the memory socket.
3
Remove memory riser board A:
NOTE:
To access the securing clips on the system board memory sockets,
it may be necessary to remove the
.
a
Press the securing clips of system board memory socket 1 outward
simultaneously until riser board A pops out slightly from the
socket.
slots (2)
securing clips (2)
memory socket