Scsi device installation guidelines, Scsi id numbers, Default scsi id settings – Dell PRECISION 530 User Manual
Page 75: Scsi, Device installation guidelines, N, see

75
NOTICE:
Dell recommends that you use only EIDE cables purchased from
Dell. Cables purchased elsewhere are not guaranteed to work with Dell
computers.
SCSI Device Installation Guidelines
This section describes how to configure and install SCSI devices in your
computer. To install a SCSI device, you can use one or both of the following
SCSI controllers:
•
The SCSI connector on the system board. To locate the SCSI system
board connector, see "
" or "
."
NOTE:
The system board SCSI controller will support hard drives only.
Do not connect CD or DVD drives, tape drives, DAT drives, and so on. An
add-in SCSI controller can be installed in your computer for this purpose.
•
A SCSI controller card installed in your computer.
SCSI ID Numbers
Internal SCSI devices must have a unique SCSI ID number from 0 to 15. If
you are using the SCSI connector on the system board and a SCSI
controller card installed in your computer, you will have two separate SCSI
buses operating. Each SCSI bus will have a set of SCSI ID numbers from 0
to 15.
When SCSI devices are shipped from Dell, the default SCSI ID numbers
for are assigned as follows:
D e f a u l t S C S I I D S e t t i n g s
System Board Controller
Optional Controller Card
Device
ID
Device
ID
Controller
7
Controller
7
Boot hard drive
0
Boot hard drive
0
CD or DVD drive
5
tape or DAT drive
6
NOTE:
There is no requirement that SCSI ID numbers be assigned sequentially or
that devices be attached to the cable in order by ID number.