Dell DX6012S User Manual
Page 50
54
Using the System Setup Program and UEFI Boot Manager
Serial Port Address
(Serial Device 1=COM1,
Serial Device 2=COM2
default)
Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
External Serial Connector
(Serial Device1 default)
Specifies whether Serial Device 1, Serial Device 2,
or Remote Access Device has access to the
external serial connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL,
configure the same port address for console redirection
and the serial device.
Failsafe Baud Rate
(115200 default)
Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Remote Terminal Type
(VT100/VT220 default)
Sets the remote console terminal type, either
VT100/VT220 or ANSI.
Redirection After Boot
(Enabled default)
Enables or disables BIOS console redirection when the
operating system is loaded.
Option
Description
book.book Page 54 Friday, February 26, 2010 11:22 AM