beautypg.com

Dell DX6012S User Manual

Page 31

background image

About Your System

31

Plug & Play

Configuration

Error

Error encountered in
initializing PCIe device;
faulty system board.

Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists,
see "Troubleshooting
Expansion Cards" on
page 141.

Quad rank DIMM

detected after

single rank or

dual rank DIMM in

socket.

Invalid memory
configuration.

Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module
Installation Guidelines" on
page 84.

Read fault

Requested sector

not found

The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective.

Replace the optical medium,
USB medium, or USB
device. Ensure that the USB
cables, SAS/SATA backplane
cables, or optical drive cables
are properly connected.
See "Troubleshooting a USB
Device" on page 130,

"Troubleshooting a Hard
Drive" on page 139, or
"Troubleshooting a Hard
Drive" on page 139 for the
appropriate drive(s) installed
in your system.

SATA Port x

device not

found

There is no device connected
to the specified SATA port.

Information only.

Message

Causes

Corrective Actions

book.book Page 31 Friday, February 26, 2010 11:22 AM