Dell DX6012S - Manual (Page 143)

Jumpers and Connectors
153
NOTE:
If you assign a new system and/or setup password with the jumper
plug still in the "disabled" position, the system disables the new password(s)
the next time it boots.
6 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7 Open the system. See "Opening the System" on page 70.
8 Move the password jumper back to the enabled position to restore the
password function. See Table 6-1.
9 Close the system. See "Closing the System" on page 71.
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "System
and Setup Password Features" on page 60.
book.book Page 153 Friday, February 26, 2010 11:22 AM