Dell PowerEdge T310 - Manual (Page 45)

About Your System
45
Memory set to
minimum
frequency.
The memory frequency
may be intentionally set
lower for power conservation. If not an intentional setting,
check any other system
messages for possible causes.
The current memory
configuration may
support only the
minimum frequency. Ensure that your memory
configuration supports the
higher frequency.
See "General Memory
Module Installation
Guidelines" on page 108.
Memory tests
terminated by
keystroke.
POST memory test was
terminated by pressing the
spacebar. Information only.
MEMTEST lane
failure
detected on x
Invalid memory
configuration. A mismatched
memory module is installed. Ensure that the memory
modules are installed in
a valid configuration.
See "General Memory
Module Installation
Guidelines" on page 108.
No boot device
available
Faulty or missing optical
drive subsystem, hard drive,
or hard-drive subsystem, or
no bootable USB key
installed. Use a bootable USB key, CD,
or hard drive. If the
problem persists,
see "Troubleshooting an
Internal USB Key" on
page 157, "Troubleshooting a
USB Device" on page 148,
"Troubleshooting an Optical
Drive" on page 158, and
"Troubleshooting a Hard
Drive" on page 160.
See "Using the System Setup
Program and UEFI Boot
Manager" on page 57 for
information on setting the
order of boot devices.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 45 Wednesday, August 19, 2009 4:40 PM