Dell PowerEdge T310 - Manual (Page 38)

38
About Your System
E2111 SBE log
disabled on
DIMM ##.
Reseat DIMM.
The system BIOS has
disabled memory single-bit
error (SBE) logging and
will not log any more SBEs
until the system is
rebooted. "##" represents
the memory module
implicated by the BIOS. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory" on
page 155.
E2113 Mem mirror
OFF on DIMM
## & ##.
Power cycle
AC.
The system BIOS has
disabled memory mirroring
because it has determined
one half of the mirror has
had too many errors. "##
& ##" represents the
memory module pair
implicated by the BIOS. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory" on
page 155.
I1910 Intrusion
detected.
Check chassis
cover.
System cover has been
removed. Information only.
I1911 LCD Log Full.
Check SEL to
review all
Errors.
LCD overflow message.
A maximum of ten error
messages can be displayed
sequentially on the LCD.
The eleventh message
instructs the user to
check the SEL for details
on the events. Check the SEL for details
on the events.
Remove AC power to the
system for 10 seconds or
clear the SEL.
I1912 SEL full.
Review &
clear log.
The SEL is full of
events and is unable to
log any more. Check the SEL for more
information and then clear
the SEL.
Table 1-2. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 38 Wednesday, August 19, 2009 4:40 PM