Dell PowerEdge T310 - Manual (Page 145)

Installing System Components
145
5 Slide the system board toward the back of the system, inserting the
connectors into the cutouts in the chassis.
6 Using a Phillips screwdriver, tighten the screws.
7 If applicable, replace the SAS backplane. See "Installing the SAS
Backplane" on page 140.
8 Replace the heat sink and processor. See "Installing a Processor" on
page 129.
9 Replace the system fan. See "Installing the System Fan" on page 107.
10 Replace all the memory modules and memory blanks. See "Installing
Memory Modules" on page 111.
11 If applicable, replace the iDRAC6 Express card. See "Installing an iDRAC6
Express Card" on page 119.
12 If applicable, replace the iDRAC6 Enterprise card. See "Installing an
iDRAC6 Enterprise Card" on page 121.
13 If applicable, replace all the expansion cards. See "Installing an Expansion
Card" on page 115.
14 Connect all the cables to the system board.
15 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89.
16 Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 87.
17 Close the system. See "Closing the System" on page 86.
18 Place the system upright on a flat surface.
19 Reattach any peripherals and connect the system to an electrical outlet.
20 Turn on the system and attached peripherals.
NOTE:
See "Running the System Diagnostics" on page 165 to verify that the new
processor operates correctly. See "Running the Embedded System Diagnostics" on
page 166 for information about running the diagnostics.
book.book Page 145 Wednesday, August 19, 2009 4:40 PM