Dell PowerEdge T310 - Manual (Page 41)

About Your System
41
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
System is in
manufacturing mode. Reboot to take the system
out of manufacturing mode.
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed. Retry the BIOS update.
If the problem persists,
see "Getting Help" on
page 177.
Caution!
NVRAM_CLR jumper
is installed on
system board
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared. Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5).
See Figure 6-1 for jumper
location. Restart the
system and re-enter
the BIOS settings. See
"Using the System Setup
Program and UEFI Boot
Manager" on page 57.
CPU set to
minimum
frequency.
The processor speed may be
intentionally set lower for
power conservation. If not an intentional setting,
check any other system
messages for possible causes.
CPU x installed
with no memory.
Memory modules are
required but not installed in
the indicated processor’s
memory slots. Install memory modules for
the processor. See
"Expansion Cards" on
page 114.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 41 Wednesday, August 19, 2009 4:40 PM