Dell PowerEdge T310 - Manual (Page 105)

Installing System Components
105
Removing a Non-Redundant Power Supply
1 Turn off the system and all attached peripherals.
2 Disconnect the power cable from the power supply.
3 Open the system. See "Opening the System" on page 85.
4 Disconnect all cables from the power supply to the system board,
hard drives and optical drive.
5 Loosen the three screws securing the power supply to the chassis and
lift the power supply to remove it from the chassis. See Figure 3-15.
Figure 3-15. Removing and Replacing a Non-Redundant Power Supply
1 non-redundant power supply 2 screws (3)
2
1
book.book Page 105 Wednesday, August 19, 2009 4:40 PM