beautypg.com

Using the cmc cli to set the ip address, Task 2: changing the ip address – Dell POWEREDGE M1000E User Manual

Page 21

background image

M5424 SAN I/O Module Hardware Reference Manual

11

53-1001082-01

Modify the SAN I/O Module IP address

2

e. From the COM Port Properties window, select the following configuration values:

Bits per second: 9600

Databits: 8

Parity: None

Stop bits: 1

Flow Control: None

For LINUX or UNIX

a. Enter the following at the command prompt:

tip /dev/ttyb -9600

b. When the terminal application stops reporting information, press Enter to display the login

prompt.

c. Log in using the default administrative account:

Login: admin

Password: password

d. When prompted either change the administrative password, or press Ctrl-C to bypass.

Task 2: Changing the IP address

1. Verify that the SAN I/O Module has completed POST. When POST is complete, the port status

and SAN I/O Module power and status LEDs return to a standard healthy state.

2. Enter the CLI ipAddrSet command.

Follow on-screen instructions and supply the correct information, as shown in the following
example.

switch:admin> ipaddrset

Ethernet IP Address [10.77.77.77]:10.32.53.47

Ethernet Subnetmask [255.255.255.0]:255.255.240.0

Fibre Channel IP Addresss [none]:

Fibre Channel Subnetmask [none]:

Gateway IP Address [0.0.0.0]:10.32.48.1

DHCP [Off]:

IP address is being changed...Done.

3. Enter ipAddrShow at the prompt to verify that the address was correctly set.

Using the CMC CLI to set the IP address

Use the following steps to connect modify the SAN I/O Module IP address through the CMC CLI.

1. Establish a Telnet session to the CMC CLI.

2. At the command prompt, type connect switch-x where x is the bay where the SAN I/O Module is

installed. For example, switch-x can be:

Switch-3 for SAN I/O Module installed in bay B1.

Switch-4 for SAN I/O Module installed in bay B2.

Switch-5 for SAN I/O Module installed in bay C1.