Dell Inspiron 3700 - Manual (Page 68)

3-24 Dell Inspiron 3700 System Reference and Troubleshooting Guide
3. Check the monitor cable for bent pins.
4. Turn off the computer, wait a minute, and then turn the computer back on. Adjust
the monitor’s brightness and contrast controls. Is the monitor readable?
Allow one minute for the computer to initialize its components.
Yes. The problem is resolved.
No. Go to step 6.
5. Raise your computer’s display into viewing position, if necessary, and press
to switch the video image from the external monitor to the display.
6. Press the down-arrow or up-arrow key combination to adjust the
brightness. Is the full display readable?
Yes. The external monitor may be defective. Go to step 8.
No. The video controller on the system board may be defective. Call Dell for
technical assistance. (See Chapter 5, “Getting Help,” for instructions.)
7. Turn off the computer and any attached peripherals. Disconnect all peripherals
from the computer. Attach another external monitor to the computer.
If you do not have another external monitor, call Dell for technical assistance.
(See Chapter 5, “Getting Help,” for instructions.)
8. Reboot the computer, and adjust the monitor’s brightness and contrast. Is the
monitor readable?
Allow one minute for the computer to initialize its components.
Yes. The original monitor is defective. Call Dell for technical assistance.
(See Chapter 5, “Getting Help,” for instructions.)
No. Call Dell for technical assistance. (See Chapter 5, “Getting Help,” for
instructions.)
! #
,,
This section provides a procedure for troubleshooting the computer’s serial and
parallel ports and any attached peripheral devices.
If a system error message indicates a port problem or if equipment connected to a
port seems to perform incorrectly or not at all, the source of the problem may be any
of the following:
A faulty connection between the I/O port and the peripheral device
Incorrect settings for Setup options
Incorrect settings in the operating system’s configuration files
A faulty cable between the I/O port and the peripheral device
A faulty peripheral device