Dell Inspiron 3700 User Manual
Page 152
C-6
Dell Inspiron 3700 System Reference and Troubleshooting Guide
Non-system disk
or disk error
The diskette in drive A or
your hard-disk drive does not
have a bootable operating
system installed on it.
If you are trying to boot from the diskette, replace it
with one that has a bootable operating system.
Not a boot
diskette
There is no operating system
on the diskette.
Boot the computer with a diskette that contains an
operating system.
Optional ROM
bad checksum
The optional ROM apparently
failed.
Call Dell for technical assistance. For instructions,
see Chapter 5, “Getting Help.”
Sector not
found
The operating system cannot
locate a sector on the
diskette or hard-disk drive.
You probably have a bad
sector or corrupted FAT on
the diskette or hard-disk
drive.
Run the appropriate utility to check the file structure
on the diskette or hard-disk drive. If a large number
of sectors are defective, back up the data (if
possible), and then reformat the diskette or
hard-disk drive.
Seek error
The operating system cannot
find a specific track on the
diskette or hard-disk drive.
If the error is on the diskette drive, try another
diskette in the drive.
Shutdown
failure
A chip on the system board
may be malfunctioning.
Run the System Board Devices tests in the Dell
Diagnostics. For instructions, see “Running the Dell
Diagnostics” in Chapter 3.
Time-of-day
clock lost
power
Data stored in NVRAM has
become corrupted.
Connect your computer to an electrical outlet to
charge the battery. If the problem persists, try to
restore the data. To restore the data, press
Then immediately exit it. If the message reappears,
call Dell for technical assistance. For instructions,
see Chapter 5, “Getting Help”
.
Time-of-day
clock stopped
The reserve battery that sup-
ports the data stored in
NVRAM may be read.
Connect your computer to an electrical outlet to
charge the battery. If the problem persists, call Dell
for technical assistance. For instructions, see
Chapter 5, “Getting Help.”
Time-of-day not
set-please run
the System
Setup program
The time or date stored in
the System Setup program
does not watch the system
clock.
Correct the settings for the Date and Time options.
For instructions, see Appendix B, “Using the
System Setup Program.”
Timer chip
counter 2
failed
A chip on the system board
may be malfunctioning.
Run the System Board Devices tests in the Dell
Diagnostics. For instructions, see “Running the Dell
Diagnostics” in Chapter 3.
(*+ 2" 4!
(
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the system Help.