Dell PowerEdge SC 430 - Manual (Page 58)

7. Connect the following cables that you removed in " Removing the System Board ." See Figure A -3 .
l Two power-supply cables to the POWER P1 and POWER P2 connectors
l If applicable, diskette data cable to the FLOPPY connector
l I/O panel cable to the FRONT PANEL connector
l 5.25-inch device data cable to the IDE connector
l Processor cooling fan cable to the FAN_CPU connector
l Card cage cooling fan cable to the CARD CAGE COOLING FAN connector
l If applicable, SATA hard-drive data cable(s) to the SATA connector(s)
8. Close the system. See " Closing the System " in " Troubleshooting Your System ."
9. Reconnect the system to the electrical outlet, and turn on the system.
Back to Contents Page