beautypg.com

The scsi select utility – Dell PowerEdge 4400 User Manual

Page 61

background image

Use the editor included with your operating system to view or print the readme.txt file or any other readme file.

The SCSISelect Utility

The BIOS for the integrated Adaptec AIC-7899 and AIC-7880 SCSI controllers includes the menu-driven SCSISelect configuration utility, which
allows you to change SCSI controller settings without opening the computer. SCSISelect also contains SCSI disk utilities that let you low-level
format or verify the disk media of your SCSI hard-disk drives.

SCSISelect Default Settings

Default settings for the integrated AIC-7880 SCSI controller are shown in

Table 1

and for the integrated AIC-7899 SCSI controller are shown in

Table 2

. These default settings are appropriate for most Peripheral Component Interconnect (PCI) systems. Run SCSISelect only if you need to

change any of the default settings.
  

For situations in which you might want or need to change the settings, see the descriptions of each setting in the following subsections. To change
any of the default settings or to format or verify a disk, see "

Starting the SCSISelect Utility

."

Table 1. AIC-7880 SCSI Controller Settings

NOTE: For the full name of an abbreviation or acronym used in this table, see the "

Glossary

."

Table 2. AIC-7899 SCSI Controller Settings

NOTES: To change the configuration settings, you must run the SCSISelect Utility twice—once for the AIC-7899 SCSI controller and
once for the AIC-7880 SCSI controller.

The term host adapter is used throughout this file to refer to the integrated AIC-7899 and AIC-7880 SCSI controllers.

If the AIC-7899 controller card does not control the bootable hard-disk drive, you may want to disable its BIOS.  Do not disable the BIOS 
for the AIC-7880 controller card, because the card controls the CD-ROM drive.

Setting

Default

SCSI Bus Interface Definitions: 

Host Adapter SCSI ID

7

SCSI Parity Checking

Enabled

Host Adapter SCSI Termination

Enabled

Boot Device Options: 

Boot Target ID

0

Boot LUN Number

0

SCSI Device/Configuration: 

Initiate Sync Negotiation

Yes (Enabled)

Maximum Sync Transfer Rate

20 MB/sec

Enable Disconnection

Yes (Enabled)

Advanced Host Adapter: 

Host Adapter BIOS

Enabled

Support Removable Disks Under BIOS As Fixed Disks 

Boot Only

Extended BIOS Translation For DOS Drivers > 1 GB

Enabled

Display Message During BIOS Initialization

Enabled

Multiple LUN Support

Disabled

BIOS Support For Bootable CD-ROM

Enabled

BIOS Support For Int 13 Extensions

Enabled

Support For Ultra SCSI Speed

Enabled

Setting

Default

SCSI Bus Interface Definitions: 

Host Adapter SCSI ID

7