Dell PowerEdge 4400 - Manual (Page 67)

12. Select the adpu160.ham driver and press .
The system prompts you for a slot number for the device.
13. Press to switch to the console prompt, type load a:\scsi\adpu160.ham, and press .
A list of slot numbers is displayed separated by commas. Write down all slot numbers that are listed and press to clear the command
line. Press to return to the installation screen.
14. Enter the slot number for the driver and press .
15. Press to save the parameters and continue.
16. When you are prompted to select an additional disk driver, select Yes.
17. Repeat steps 13 through 17 for each driver as necessary.
18. Select Continue the Installation to create disk partitions and system volumes and to specify volume names following the procedures listed
in the NetWare User's Guide.
19. To load the driver automatically at server start-up, make sure the startup.ncf file includes the load command line and correct slot number for
your host adapter. Refer to the NetWare User's Guide for information about editing the startup.ncf file.
Installation for NetWare 5.0
This section provides information on installing the SCSI drivers for the Novell NetWare 5.0 operating system. Instructions assume that NetWare 5.0
is installed and operational.
Creating the NetWare 5.0 SCSI Driver Diskette
If you have not already done so, use the Dell OpenManage Server Assistant CD to create a NetWare 5.0 SCSI driver diskette. See " Using the
Dell OpenManage Server Assistant CD " for instructions on creating the diskette.
Uninstalling a SCSI Driver
If you are replacing an existing driver (for example, because it has become corrupted or an upgrade has become available), you must first remove
the installed driver. To remove a driver, perform the following steps:
1. At the initial NetWare screen, press to display the NetWare console screen.
2. At the server prompt, type nwconfig and press .
The NetWare Configuration screen appears, displaying the Configuration Options menu.
3. At the Configuration Options menu, highlight Driver Options and press .
4. At the Driver Options menu, highlight Configure disk and storage device drivers and press .
5. At the Additional Driver Actions menu, highlight Unload an additional driver and press .
6. At the Selected Disk Drivers menu, highlight the driver that you want to uninstall and press .
7. At the message Driver xxx successfully unloaded, press .
The Additional Driver Actions menu appears.
From the Additional Driver Actions menu, you can repeat steps 5 through 7 to uninstall an additional driver, start with step 5 of the next
procedure to install a driver, or press to exit.
Installing the SCSI Drivers for NetWare 5.0
To install NetWare 5.0 SCSI drivers from the NetWare 5.0 SCSI driver diskette that you created, perform the following steps:
1. At the initial NetWare screen, press to display the NetWare console screen.
2. At the server prompt, type nwconfig and press .
The NetWare Configuration screen appears, displaying the Configuration Options menu.
3. At the Configuration Options menu, highlight Driver Options and press .
NOTE: Specific help text for each driver appears in the middle of the screen as you scroll down the list. The Loaded Drivers
window below the list of available drivers displays the names of drivers that are loaded and operational. For a new installation, this
list is initially empty. For a selective installation, the list shows the drivers already running.