Dell XPS M1730 (M1730, Late 2007) - Manual (Page 42)

42 Display Assembly
6 Disconnect the light lobes connector using the pull-tab.
7 Remove the display panel.
Replacing the Display Panel
1 Replace the light lobes connector.
2 Replace the eight screws that attach the display panel brackets to each side
of the display panel.
3 Align the display panel with the display back and replace the four screws.
4 Connect the LCD camera cable to the display panel.
5 Route the cables back through their routing channels.
6 Replace the display bezel (see "Replacing the Display Bezel" on page 41).
Removing the Display Panel Cable
1 Remove the display assembly (see "Removing the Display Assembly" on
page 37).
2 Remove the display bezel (see "Removing the Display Bezel" on page 40).
3 Remove the display panel (see "Removing the Display Panel" on page 41).
4 Turn over the display panel, placing it on a clean surface.
NOTICE: To avoid damage to the computer when replacing the bottom flex cable,
gently support the bottom of the inverter board with one finger as you reseat the
bottom flex-cable connector. Do not bend the inverter board.
5 Gently pull the pull-tab from the bottom flex-cable connector to release
the cable from the inverter board.
6 Squeeze the flex-cable release levers at either side of the top flex-cable
connector, releasing the connector.
1 camera cable connector 2 display panel
3 screws (12) 4 light lobes connector