Installing a raid controller card, Connecting the card – Dell PowerEdge 1850 User Manual

Page 61

Text mode
Original mode

14.

Install and configure the RAID software.

See the RAID software documentation for more information.

Installing a RAID Controller Card

See "

Installing an Expansion Card

" in "Installing System Components" for instructions about installing the card. See the RAID controller documentation for

information on installing and configuring the RAID software.

Connecting the Card

After installing the card, connect the card to the system's SCSI backplane using the new SCSI cable supplied with the card.The new cable replaces the cable
extending from the riser card to the connector on the underside of the SCSI backplane.

Back to Contents Page

NOTICE:

A newly-installed RAID battery must be charged for three to four hours of system operation before you can operate the RAID controller in

write-back mode.