Advanced settings – Corega CG-WLNCM4G User Manual

Page 44

Advanced Settings

3.10 Advanced Configuration When the

Camera Is behind a NAT Router

If your camera is connected to a NAT router, you need to open a “Virtual
Server” port for the camera in the router to allow remote network
access. Here we use corega WLBARGMO wireless router as an example:
(as the image below)-.

Step 1:

Select the IP address and name of the camera

Step 2:

Select a service, for example, HTTP.

Step 3:

Enter the port range. The recommended port range is 80~80.

If you have a second (or more) camera connected, you need to assign
a different port range (can not use 80~80 again) for it. Besides, the port
value has to be the same as the camera's HTTP port. (Please also refer
to chapter 3.2.1)

Step 4:

Select a protocol. "TCP" is recommended.

Step 5:

You can add product description in the “Remark” column

Step 6:

Click [Submit] after you enter all the information. You will then

see the new entry in the Virtual Server list.

HTTP