Cabletron Systems DLE22-MA - Manual (Page 112)

Chapter 5: Local Management
5-48 DLE22-MA,DLE32-MA,DLE23-MA and DLE33-MA User’s Guide
Management or UPS applications. Select DISABLED if you wish to
disable the COM port for additional module security.
Figure 5-19 COM Port Warning Screen
3. Use the arrow keys to highlight YES. Press ENTER.
4. If you ENABLED the port, proceed to Section 5.15.12. If you
DISABLED the port, use the arrow keys to highlight SAVE at the
bottom of the screen, then press ENTER. When the message “SAVED
OK” displays, the edits are saved.
!
If the COM port is reconfigured without a valid IP address set
on the module or chassis, the message shown in Figure 5-19
displays. Do not continue unless the outcome of the action is
fully understood.
If the DLM6C-AA chassis has been configured with a valid IP
address this screen will not appear. When the chassis is
assigned a valid IP address all the interface modules installed
share this same address.
WARNING
LKG-10849-98F
THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP
ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE
TO MANAGE THIS BOARD. DO YOU STILL WISH TO RECONFIGURE
THIS COM PORT?
YES NO