Cisco SFS 7008 - Manual (Page 93)

93
• Standard page 93
• Extended
• Extended Memory
Run a Chassis Standard Test
The chassis standard diag test runs a diagnostic test on all cards in the chassis.
1. Enter the diag chassis test standard and start commands to initiate the test.
Example
2. Enter the show diag chassis command to show the status of the diag test.
Example
Topspin-270> enable
Topspin-270# config
Topspin-270(config)# diag chassis test standard
Topspin-270(config-diag-chassis)# start
Topspin-270(config-diag-chassis)#
Topspin-270(config-diag-chassis)# exit
Topspin-270(config)# exit
Topspin-270# show diag chassis
================================================================================
Diagnostic Tests For Chassis
================================================================================
module-type : chassis
module-number : 1
test : standard
iterations : 1
option : none
action : start
result : success
percentage-completed : 100
result-string : Standard System Test Completed, Final report : Passed=1,
Failed=0, Total=1
Topspin-270#