Cisco SFS 7008 - Manual (Page 43)

43
5. Use a #1 phillips screwdriver to unscrew the captive screws from both ends of the Fabric Controller
card.
Figure 3-9: Loosen Captive Screws Before Removing
6. Pull the levers on both sides of the card toward you. The card will be released.
Figure 3-10: Opening Fabric Card Levers
7. Use the levers to pull the card toward you and remove it from the bay.
8. Place a blanking panel over the open bay. No bay should ever be run without a blanking panel or a
module installed, as overheating may occur.
or
Refer to “Installing a Fabric Controller” on page 44 to install a new fabric controller.