Chassis id leds – Cisco SFS 7008 User Manual
Page 74
74
Master Management Connection Status LED
The Master Management Connection Status LED is a single LED that indicates whether that particular
Management Interface module is connected to the system's active master controller.
Refer to
Figure 5-5
to view the location of this LED.
Ethernet Management Port RJ-45 connector LEDs
Refer to
Figure 5-5
to view the location of this LED.
Chassis ID LEDs
Figure 5-7: Chassis ID LEDs
The Chassis ID Status LED indicates the status of this module.
Table 5-10: Interpreting the Power Supply Status LEDs (see
Color
State
Indication
Green over Yellow
off
No fan module installed, or LED failure.
Green
solid on
Power supply is running with no errors detected.
Green
off
No power to the Power supply, LED failure, or yellow LED is
On.
Yellow
solid on
Failure of the Power Supply. Operator attention required.
The “!” label indicates a failure.
Table 5-11: Interpreting the Master Management Connection LEDs (see
)
Color
State
Indication
Green
off
Management module is not connected to the active master
controller, or is connected to the system's standby master
controller.
Green
solid on
Management module is connected to the system's active master
controller.
Table 5-12: Interpreting the Ethernet Management Port LEDs (see
)
Location
State
Indication
Left port LED
off
Port is not connected or logical link is down.
Left port LED
on
Port is connected and logical link is up.
Right port LED
off
No traffic is moving on the Ethernet Management port link.
Logical link may or may not be Up.
Right port LED
on
Traffic is moving on the Ethernet Management port link.