Cisco SFS 7008 - Manual (Page 41)

41
or
Install a new fan module. Refer to “Installing a Fan Module” on page 41 if you are installing a new
fan module.
Installing a Fan Module
1. Remove the new fan module from the package.
2. Ground yourself appropriately.
3. Remove the bezel cover from the front of the switch, if you have not already done so.
4. Refer to
“Removing a Fan Module” on page 39 , if a module is still in place.
5. Remove the blanking panel, if no fan module was in place.
6. Align the fan module with the bay and slide the module into the bay.
Figure 3-7: Pushing Fan Module into Slot
7. Push the module until it is firmly in place.
8. Use the #1 phillips screw driver to tighten the captive screws.
Figure 3-8: Tightening Captive Screws