Baumer NE215 - Manual (Page 18)

18
NE215
Programming segment 3
Programming segment 3 begins with programming line 21.
14 programming lines are displayed in sequence in these segments.
Default settings are always printed with * .
Line 21 Operating modes
0 * Step preset
1
P1 Self-adjusting preset
Line 23 Multiplier, secondary counter
1 * 1
2
2-99
Line 26 Frequency, secondary counter XB
0 * 10 kHz
1
25 Hz
2 15 Hz
Line 30 Reset secondary counter
0 * Autom. reset and external static
1
Autom. reset and external differential
2 External static
3 External differential
Line 31 Output time P1
00.00 * Data in Sec. (Tol. -0.01 s, range 00.02 -99.99 s)
00.25 0.25
99.99 Maximum puls time
LAtch Latch= continuous signal
Line 32 Output time P2
00.00 * Data in Sec. (Tol. -0.01 s, range 00.02 -99.99 s)
00.25 0.25
99.99 Maximum puls time
LAtch Latch= continuous signal
Line 33 Output time B1
00.00 * Data in Sec. (Tol. -0.01 s, range 00.02 -99.99 s)
00.25 0.25
99.99 Maximum puls time
LAtch Latch= continuous signal
Line 34 Accept presets P1, P2 and B1
0 * On reset
1
Effective immediately
Line 35 Adresses for function key
0 * No function
1
Any parameter selection
:
8
Programming mode