Crestron electronic CEN-CN - Manual (Page 22)

Ethernet/Cresnet Interface Crestron CEN-CN
18
••
Ethernet/Cresnet Interface: CEN-CN Operations Guide - DOC. 5721
Typical Connections for Normal Operation
CRESTRON ELECTRONICS INC. ROCKLEIGH, N.J. 07647 USA CRESTRON ELECTRONICS INC. ROCKLEIGH, N.J. 07647 USA
12VDC
.5A
ETHERNET P C
NET
Y
NET
2 4 G Z Z G Y 2 4
NET
TO LAN/WAN
VIA HUB
TO CRESNET
DEVICES
FROM EXTERNAL
AC POWER PACK
(OPTIONAL. OPERATING
POWER MAY BE SUPPLIED
VIA CRESNET WIRING)
TO CRESNET
DEVICE OR
SMARTOUCH
MODULE
Communications
Communicating via Ethernet
NOTE: Before performing this procedure, refer to “Hookup Diagram for Normal
Operation” on page 17 for cabling instructions.
The Crestron Viewport may be used to communicate with the CEN-CN via Ethernet.
This is useful for changing the IP Table or updating the UPZ. The CEN-CN needs to
be configured via the serial port for the first time (IP Address, etc). Refer to “Initial
IP Setup” on page 13. To connect the Viewport to the unit, perform the following
procedure.
1. In the Viewport, select Remote | TCP/IP | Connect as shown below.
Viewport Connect TCP/IP Function