Humboldt H-4140 GeoGauge - Manual (Page 10)

10
Announces the measured value of stiffness (MN/m),
(displayed in ID window). The measured value of stiffness is
displayed simultaneously in the STIFFNESS window.
Indicates that the current measurement was aborted due to the
sensors being overloaded. The word "SENS" is displayed in the
ID/TARGET window and the word "OvLOAD"is displayed in the
STIFFNESS window. This can be caused by a too soft material,
a too stiff material or the foot being seated improperly. When
displayed, the current measurement must be repeated.
Announces the standard deviation of all 25 frequency
dependent stiffness measurements relative to the measured
(average) value of stiffness (displayed in ID/TARGET window) at
the end of the current measurement. The standard deviation is
displayed simultaneously in the STIFFNESS window.
Indicates that the GeoGauge is measuring ambient noise
(displayed in ID/TARGET window). The noise measurement
takes about 10 seconds after depressing the MEAS button.
Nothing is displayed simultaneously in the STIFFNESS window.
Indicates that the GeoGauge is taking stiffness data over
25 frequencies between 100 and 196 Hz (displayed in ID/
TARGET window). This follows the noise measurement and
takes about 55 seconds. Nothing is displayed simultaneously in
the STIFFNESS window.
Announces the display of the Signal Noise Ratio for the current
measurement (displayed in ID/TARGET window) at the end
of the current measurement. The Signal Noise Ratio, in dB, is
displayed simultaneously in the STIFFNESS window.
This message indicates the ready mode and the stiffness units
(displayed in ID/TARGET window). The GeoGauge is ready to
take the next measurement. The Stiffness window shows the
value of the last measurement, in SI units (MN/n) or English (Eg)
units (klbf/in).
Indicates that the current measurement value has already been
stored in the memory. The word "AlrE"" is displayed in the
ID/TARGET window and the word "StorEd"is displayed in the
STIFFNESS window. If you don't know if the last measurement
has been stored, the GeoGauge will tell you.
StiF
SENS OvLOAD
5d
noiS
dAtA
Snr
5I or Eg
ALrE StorEd
4.0: Display Messages