Bio-Rad Model 550, Ultramark, and Benchmark Microplate Reader Accessories - Manual (Page 22)

e. When the desired row is chosen, press NEXT to move the cursor to the column
position.
f. Again, use either ARROW to step up or down between 1 and 12 until the desired
column number is displayed.
g. The check box on the bottom line of the display will be darkened if the chosen well
is presently defined as blank. If the well is not presently defined as blank, then
the check box is empty. To change the status of a well, press SELECT. If the
check box had been darkened, it will be emptied, and if the check box started out
as empty, it will be darkened.
h. Press ENTER to seal the selection/editing of the blank well(s). The display will
return to the previous screen.
8. Press ENTER to return the screen to
Set Limits Mode
If either the Matrix or Limit report is selected, then Upper and Lower limits must be
defined in the Set Limits mode. The Upper limit may not exceed 3.500, nor may the Upper
limit be less than the Lower limit. If either of these situations occurs, an error message will be
displayed.
1. Press MODE until the display reads
2. Press either ARROW until the display reads
3. Press ENTER. The display changes to read
19
■ ■ Clear Blanks
■ ■ Col ■ ■ Row ■ ■ Well
>SET BLANKS
MODE
>PRINT REPORT
MODE
>SET LIMITS
MODE
Err: Max=3.500
Press any key
Err: Lower>=Upper
Press any key
Upper= 3.500
Lower= 0.000