Bio-Rad Model 550, Ultramark, and Benchmark Microplate Reader Accessories - Manual (Page 14)

Format No. 5:
Format No. 6:
Notes:
1. Blank wells that have been defined under the SET BLANKS mode are
replaced by those of the templates. In order to set blanks in the SET
BLANKS mode, the number of standards and the number of samples must
be set to zero in the SET CONCENTRATION mode (see Section 4.3).
2. If the standards are set to zero, then an error message will be printed on
the fourth line of the Concentration report, ERROR: STDs=0.
3. If the standards are not input in ascending or descending order, an error
message will be printed on the fourth line of the Concentration report,
ERROR: STD Conc.
11