Bio-Rad Bio-Plex Pro™ Rat Cytokine, Chemokine, and Growth Factor Assays - Manual (Page 31)

29
2. Click Select Analytes and create a new panel. Visually confirm the
selected analytes and proceed to step 3.
a. Click the Add Panel button in the Select Analytes toolbar.
Enter a new panel name. Select Bio-Plex Pro Assay Magnetic
from the assay pull-down menu. If using Bio-Plex Manager version
5.0 or lower, select MagPlex from the assay pull-down menu.
b. Click the Add button. Enter the bead region number and name
for the first analyte. Click Add Continue to repeat for each
analyte in the assay.
For reference, bead regions are shown in Table 25.
c. Click the Add button when the last analyte has been added and
click OK to save the new panel.
d. Highlight analytes from the Available list (left) and move to the
Selected list (right) using the Add button. To move all analytes at
once, simply click the Add All button.
e. If some of the analytes need to be removed from the Selected
list, highlight them and select Remove. If desired, it is possible to
rename the panel by clicking on Rename Panel and entering a
new panel name.
Note: Do not use preset panels found in Bio-Plex Manager
software version 5.0 or earlier as the bead regions are not
up to date.