Bio-Rad Sequi-Gen GT Sequencing Cell - Manual (Page 9)

Construction Specifications
GT IPC panel Injected molded polycarbonate
GT safety covers Injected molded polycarbonate
Universal base Injected molded polycarbonate
Stabilizer bar Injected molded polycarbonate
GT clamp set PVC clamp body
Protruded G10 polyester/glass cam shaft
Polycarbonate insulated stainless steel rod
Glass plates Chemically tempered 4.8 mm float glass
Combs and spacers Plastic or machined vinyl (see Sections 2.7 and 6.1)
Electrodes (IPC and base) Platinum, 0.25 mm diameter
Banana plugs (IPC and base) Gold plated stainless steel, 5.08 cm length
Electrical cables Dual, 20 AWG, tinned copper wire cable
Flame retardant polyurethane insulation jacket
Electrical leads Polyurethane insulated nickel silver, 2.95 cm length
Precision caster base Injection Molded Polycarbonate
Tubing Polyurethane, 3.2 mm internal diameter,
4.8 mm outer diameter
Luer taper Polypropylene, 3.2 mm internal diameter
Gasket Silicon Foam Sponge
Syringe Polypropylene, 60 cc or 140 cc
Drain port connector Polypropylene (quick coupling assembly)
3.2 mm internal flow diameter
Section 2
Description of Major Parts
2.1 Sequi-Gen GT Parts
See Figures 2.1 and 2.2 for Sequi-Gen GT part identification.
Fig. 2.1. Sequi-Gen GT gel casting parts.
6
Syringe
Tubing
Luer Taper
Precision Caster Base
Syringe
Sharkstooth Comb
Leveling Bubble
Drain Port
Precision Caster Cam Peg Precision Caster Base Injection Port
GT Lever Clamps