Bio-Rad Components for Older Model Spot Cutter - Manual (Page 6)

N No otte e:: This Bio-Rad instrument is designed for laboratory use only and is certified to meet
EN-61010 safety standards. Operation of this product is subject to the condition that no harmful radio
interference is caused and that any interference must be accepted. Certified products are safe to
use when operated in accordance with the instruction manual. This instrument should not be mod-
ified or altered in any way. Alteration of this instrument will
• Void the warranty
• Void the EN61010-1 certification, and
• Create a potential safety hazard
Bio-Rad is not responsible for any injury or damage caused by use of this instrument for purposes
other than those for which it is intended or by modifications of the instrument not performed by
Bio-Rad or an authorized agent.
* EN61010-1 is an internationally accepted electrical safety standard for laboratory instruments.
Section 2
Installation
2.1 Unpacking the Enclosure
To unpack the Enclosure:
1. Remove any external tape or banding and lift the outer box off the top of the
packing base.
2. Remove the black base-mat from the packaging on top of the Enclosure.
3. Remove the foam packaging from the top of the Enclosure.
4. Lift the inner packing sleeve off the Enclosure. The Enclosure should now be
exposed but still resting on the base foam.
5. Lift the Enclosure straight up off the foam base. Set it on the bench or floor.
6. Unpack the two boxes remaining in the base packaging material. The larger box
contains the UV-B light assemblies, and the smaller box contains the bandpass
filter kit.
3