B&G V90 VHF Radio - Manual (Page 94)

94 |
Setup | V90 Operating Manual
GPS setup
If a GPS receiver is connected to the NMEA port of the V90, the radio
will automatically receive the vessel’s position and local time from
the GPS.
If GPS data is not available for some reason, the radio will sound the
NO GPS alert for 2 minutes (or until you press any key).
If the GPS data becomes older than 4 hours, the NO GPS alert will
sound, and it can only be silenced manually or by the reception or
manual entry of new GPS data.
If the vessel’s GPS data is older than 23.5 hours, the data will be
erased and the NO GPS alert will sound.
Manually entering position and UTC time
¼ Note: This function is only shown when there is no GPS receiver
connected.
1. Select MENU → GPS/DATA → MANUAL.
2. Enter the latitude, then the longitude, then the UTC.
When you have finished, the latitude, longitude and UTC time will
be shown on the standby screen. The prefix M indicates a manual
entry.
¼ Notes:
• Manual entries are cancelled if a real GPS position is received.
• A warning will be displayed after 4 hours to remind you that the
current position information was manually entered.
DSC
MENU SELECT
BUDDY LIST
LOCAL/DIST
CONTRAST
GPS/DATA
USA
16
Hi
DSC
PRI
GPS/DATA
MANUAL
SETTING
GPS SOURCE
USA
16
Hi
DSC
PRI
USA
A
RESTRICTED
12:28 LOC
M27 56.020 N
082
16
Hi
DSC
PRI
50.190 W