B&G V90 VHF Radio - Manual (Page 43)

| 43
Waypoint procedures | V90 Operating Manual
Navigating to a waypoint
Navigating to a waypoint requires two steps:
• Selecting which waypoint you want to navigate to.
• Pressing [NAV] to go to Navigation mode.
These steps are explained below.
Selecting a waypoint from your list
1. Select MENU → WAYPOINT → WP LIST.
2. Press [OK] and then scroll to the required waypoint and press [OK]
again.
3. Select GO.
4. When prompted, select YES.
When in Navigation mode (see below), the distance and bearing
from your current position to the selected waypoint will be
displayed on the bottom line of the standby screen.
Selecting the nearest waypoint
¼ Note: This option is only available when a valid signal from a GPS
device is present.
1. Select MENU → WAYPOINT → NEAREST WP.
The display shows your list of waypoints with the nearest at the top.
2. Scroll to the required waypoint and press [OK].
When in Navigation mode, the distance and bearing to it from your
current position will be shown on the bottom line of the standby
screen.
WAYPOINT
NEAREST WP
WP LIST
USA
C
16
Hi
DSC
PRI
WP LIST
NEW WP
HARBR
USA
FISH1
FISH2
C
16
Hi
DSC
PRI
FISH2
WP EDIT
DELETE
GO
TX WPT DATA
USA
C
16
Hi
DSC
PRI
WAYPOINT
WP LIST
NEAREST WP
USA
C
16
Hi
DSC
PRI
NEAREST WP
FISH1
2
FISH2
8
m
USA
t
t
n
m
n
075
243
C
16
Hi
DSC
PRI