B&G V90 VHF Radio - Manual (Page 34)

34 |
Operating procedures | V90 Operating Manual
Three favorite channels 3CH
• Once set up, you can use the three favorite channels in two ways:
• Repeat press [3CH] to toggle between your three favorite
channels, or
• Scan the three channels and the priority channel.
To add a favorite channel:
• To add a favorite channel for the first time, select that channel then
hold 3CH to store it in the CH1 location.
• You can repeat the procedure to store two more favorite channels in
the CH2 and CH3 locations respectively.
• Once the three locations are full, if you try to add another favorite
channel, the radio will overwrite the CH3 location after prompting
you to confirm.
To delete a favorite channel:
• Select that channel and then hold down [3CH]. The radio will
remove that favorite channel after prompting you to confirm.
To toggle between your three favorite channels:
• Press [3CH] to enter 3CH mode.
• The radio displays “3CH MODE” and CH1, CH2, or CH3 to show which
of your favorite channels is currently selected.
• Repeat press [3CH] to switch between the three channels.
To exit 3CH mode:
• Press [X].
Scanning channels
The V90 can automatically monitor more than one channel at the
same time. It scans a selected range of channels, and when a valid
signal is received, the radio stops scanning and remains on that
channel so that you can hear the communication. However, if the
signal from the channel ceases for more than 5 seconds, the scan
automatically restarts.
Four scan modes are provided:
• All scan
Scans all available channels in sequence, but also checks the priority
channel every 2 seconds.
DSC
OVER WRITE
CH3?
YES
NO
Lo
USA
A
03
DSC
Hi
USA
CH1
D
3CH MODE
DELETE CH1?
YES
NO
16