Great Plains NP3000A Predelivery Manual - Manual (Page 28)

24 NP3000 Table of Contents Index Great Plains Manufacturing, Inc.
407-613Q Table of Contents Index 03/31/2011
Install Manual Pak
Refer to Figure 35
If the manual pak
is already installed on the imple-
ment, continue at “Final Setup” on page 25.
1. Select one:
118-652D MANUAL PAK MOUNT
and two:
806-069C U-BOLT 1/2-13 X 4 1/32 X 7 1/4
and four sets:
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Install the mount , with the break up to the rear, on
the lift-assist main cross-tube, just right of the rear
hitch. If there is no rear hitch, install the mount near
implement center-line.
If the manual pak enclosure is already installed on the
mount , continue at “Final Setup” on page 25.
2. Select one:
817-853C MANUAL PAK 2 1/4 THK
and four sets:
802-005C HHCS 1/4-20X1 GR5
817-042C MINI END WHEEL PRESS WHEEL
803-255C NUT HEX NYLOCK 1/4-20
Insert the bolts from inside the pak enclosure.
Add the elastomer washer/stand-off and mate to
the mount . Secure with lock nuts .
Figure 35
Manual Pak
32049
60
37
43
50
11
40
59
30
60
11
50
43
37
11
60
11
60
30
59
40
30
59
11 40