Great Plains NP3000A Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Table of Contents Index Unload Trailer 7
03/31/2011 Table of Contents Index 407-613Q
Unload Miscellaneous Components
Refer to Figure 3
Use hoists or fork lifts to remove all pallets, crates and
loose sub-assemblies from the trailer bed.
Check serial numbers on components and crates
against the serial number plate of the implement. If the
shipment included multiple implements, particularly for
multiple destinations, it is critical to unload all (but only)
the extra components for the implement.
Falling Implement Hazard:
Do not release any chains or straps securing the applicator
itself to the trailer bed until the applicator is fully supported by
the lifter(s). Some applicator configurations could tip to one
side or the other if not tied down or fully supported. This could
result in equipment damage, serious injury or death.
Pre-Lift Inspection
Any Model Shipped Unfolded
Refer to Figure 4
If the implement was shipped unfolded, verify that there
are wing pivot blocks
at both wing pivots. If a block is
missing at either wing, contact the factory. If the wings
are not blocked, they will droop at lift, and coulter dam-
age is possible when the implement is set down.
Figure 3
Crate and Gauge Wheels
32108
3
3
Figure 4
Wing Pivot Shipping Block
31681
4
4